topic Re: Why can't Fusion import or upload this dxf file? in Fusion Support Forum

Why can't Fusion import or upload this dxf file?

jonavark — Fri, 10 May 2024 16:35:18 GMT

See attached file.

Re: Why can't Fusion import or upload this dxf file?

g-andresen — Fri, 10 May 2024 17:51:48 GMT

Hi,

The file cannot be opened in ACAD and Inkscape either.
Try to convert it to another format (R13) using a viewer.

günther

Re: Why can't Fusion import or upload this dxf file?

MRWakefield — Fri, 10 May 2024 17:36:28 GMT

I managed to open it in CorelDRAW 2018, Inkscape, Affinity Designer and nanoCAD without issue. I think it just that it's an older version than Fusion supports, anyway, I saved it from nanoCAD as R2013 (see attached) and checked it imports into Fusion.

Hope this helps.

Re: Why can't Fusion import or upload this dxf file?

jonavark — Fri, 10 May 2024 18:57:34 GMT

wow. I owe you a beer! I'll check it out today. Thank you very much.

Well.. yeah. it is missing the imagery I need. But I do really appreciate your help. That was very nice of you to take the time to do.

Re: Why can't Fusion import or upload this dxf file?

MRWakefield — Fri, 10 May 2024 19:18:16 GMT

You're welcome. It only took a couple of minutes so it was no bother.

BTW, it's always good practise to reply directly to a post rather than the thread in general by using the "Reply" button

instead of the "Post Reply" button

This helps people keep track of what's going on in a thread.

Good luck with the guitar!