topic Inspect->Measure: How to get rid of label? in Fusion Support Forum

Inspect->Measure: How to get rid of label?

alanwhereareyou — Fri, 28 Dec 2018 15:26:08 GMT

Hi, Fusion 360 has started sticking measure-labels on the workarea when I use the inspect-measure tool. Almost always, the label is blocking the features I want to select. See below: The "1" label is right on top of the second measurement point.

I swear this is new from the last update. Can I do anything about this?

Re: Inspect->Measure: How to get rid of label?

ryan.bales — Fri, 28 Dec 2018 19:16:25 GMT

As far as I remember this has not changed. This is the selection count and label showing what and what order. I get that it can be annoying. Maybe @Phil.E has some insight on this?

Re: Inspect->Measure: How to get rid of label?

Phil.E — Sat, 29 Dec 2018 19:28:14 GMT

This looks like something may have changed. I could be mistaken but I think if we had turned off the heads up tags it was because the options were already shown in the dialog. In any case, the tags are too close to the points, they partially obscure the point, which is a minor bug itself.

You'll notice that if you right click and repeat the measure command the tags are not shown. Also, you should be able to zoom a little if the tag is in the way. Zoom is your friend for measurements in such a small area.

So something is inconsistent. @ryan.bales Can you log these issues (the inconsistency and the tag behavior) and assign them to me? I can track it down next week.