topic Re: Splitting Problem in Fusion Support Forum

Splitting Problem

Anonymous — Sat, 09 Feb 2019 12:00:59 GMT

I have been successfully splitting a yacht hull body for 3D printing and then removing the body not required. Suddenly although the split body appears to work when I try to remove the unwanted part it doesn't go. However if I drag the whole hull it leaves the part I want but I end up with two bodies although it only says one body. Any ideas please

Re: Splitting Problem

TrippyLighting — Sat, 09 Feb 2019 12:47:38 GMT

Please share you model. (export as .f3d and attach to post)

Re: Splitting Problem

Anonymous — Sat, 09 Feb 2019 18:24:33 GMT

File attached. I split at 200mm from the bow

Re: Splitting Problem

TrippyLighting — Sat, 09 Feb 2019 18:31:45 GMT

You are using way too many spine points. I'd venture a guess that most of this curves need a maximum of three.

That results in better surfaces and such problems as splitting disappear.

Re: Splitting Problem

TrippyLighting — Sat, 09 Feb 2019 18:35:04 GMT

Im am not sure I understand the problem. You have two bodies that box have the same geometry.

Can you make a screencast and explain you problem in more detail ?

Re: Splitting Problem

Anonymous — Fri, 15 Feb 2019 11:59:30 GMT

Thanks everyone for your interest in my problem. I reverted to an earlier version and it splits OK so don,t know what the problem was but all working fine now