topic Re: Anomaly when extruding a sketch that touches patterned components in Fusion Support Forum

Anomaly when extruding a sketch that touches patterned components

tmostad — Mon, 18 Mar 2019 14:53:38 GMT

I have a project that consists of linear pattern of components and when I draw then extrude a sketch that touches the tops of the components I see what looks like a bug. See the screencast.

Re: Anomaly when extruding a sketch that touches patterned components

julia.paganucci — Mon, 18 Mar 2019 15:07:18 GMT

Hi @tmostad ,

Thanks for posting! I do not see any screencast attached. Can you please post a link to the screencast as well as your design that you are referencing?

Thanks,

Re: Anomaly when extruding a sketch that touches patterned components

tmostad — Mon, 18 Mar 2019 15:10:36 GMT

My Fusion 360 started to report an outage so I rebooted and maybe 10 seconds later the outage message cleared and the problem went away. So never mind!

Re: Anomaly when extruding a sketch that touches patterned components

tmostad — Mon, 18 Mar 2019 15:35:03 GMT

Spoke too soon. Problem is still there. Hopefully the screencast will work this time.

Re: Anomaly when extruding a sketch that touches patterned components

julia.paganucci — Mon, 18 Mar 2019 15:48:00 GMT

HI @tmostad ,

That seems strange, can you please share your file here so that I can take a closer look?

Thanks,

Re: Anomaly when extruding a sketch that touches patterned components

tmostad — Mon, 18 Mar 2019 16:00:10 GMT

https://a360.co/2HFpmkj

(Not sure if I am doing this right)

Re: Anomaly when extruding a sketch that touches patterned components

tmostad — Mon, 18 Mar 2019 16:45:55 GMT

OK, I figured out what I was doing wrong. When I was doing the extrude Join was the default so it was joining the sketch to the pattern which was creating a really funky result. When I switched to new component (which is what I want) then I get the result I want.