topic Re: center lines disappearing in Fusion Support Forum

center lines disappearing

MariusBaard — Wed, 20 Mar 2019 09:35:53 GMT

I have made a part and only afterwards used the bend from flat to bend 2 hooks 45 deg.

Now that I go to flat pattern the center lines is missing.

That should not happen

Re: center lines disappearing

karina.harper — Wed, 20 Mar 2019 23:08:28 GMT

Hi @MariusBaard

Can you share the file so I can take a look?

Thanks,

Karina

Re: center lines disappearing

MariusBaard — Mon, 25 Mar 2019 06:29:17 GMT

Hi Karina

I will, as soon as I can get into Fusion. It keeps on hanging on start.

It sounds like a network problem.

Should Fusion not still start but in offline mode if there is no network?

Re: center lines disappearing

karina.harper — Mon, 25 Mar 2019 20:59:11 GMT

Hi @MariusBaard

Fusion should start in offline mode if you have no network connection, yes. Is it working now?

As for your file, @ryan.bales and I have not been able to reproduce from scratch. I'll log this with the development team and they can have a look. It might be specific to your file.

Thanks for reporting this - have you seen it anywhere else?

Cheers,

Karina

Re: center lines disappearing

MariusBaard — Tue, 26 Mar 2019 08:03:17 GMT

Hi Karina

We seem to have a problem with our network, I have allowed it through the firewall but we still had to do the comparability thing to windows 7. I am running windows 10

No I have not seen it anywhere else as this was the first time I used this function in Fusion, have used it in Creo a lot of times before.

But look at all the other parts in the design with bends, they do the same thing

Re: center lines disappearing

nikhil.naikNLKQG — Wed, 27 Mar 2019 12:56:49 GMT

Hi @MariusBaard

Analyzed the part file you provided and I could reproduce the issue with simplified part file. It appears, for this type of bend, the bend line position - Center is causing some issues. While this problem will further be drilled down, here are some quick workarounds -

1) If bend relief is not required - Either turn off the checkbox on dialog or extend the bend line on both sides.

2) If bend relief is required - Use separate bend lines for creating two bends or set bend line position to Start.

Please refer to the video attached, simplified part file & your part file with workaround applied, for detailed information. Hope it helps.

Re: center lines disappearing

MariusBaard — Wed, 27 Mar 2019 13:36:21 GMT

Hi Nikhil

Thank you.

I will try your solution later when I have a minute to spare.

Kind regards

Marius

Re: center lines disappearing

MariusBaard — Thu, 28 Mar 2019 09:32:20 GMT

Hi Nikhil

Separate lines did the trick, thanks.

But please work on the possibility of doing a single line as it saves time, and time is money