https://forums.autodesk.com/t5/fusion-support-forum/chamfering-trick-wanted/m-p/12835924#M15078 <P>Hi,</P> <P>please share a file for reply</P> <P>File &gt; export &gt; save as f3d on local drive &gt; attach to post</P> <P>&nbsp;</P> <P>günther</P> Wed, 12 Jun 2024 21:10:57 GMT g-andresen 2024-06-12T21:10:57Z https://forums.autodesk.com/t5/fusion-support-forum/chamfering-trick-wanted/m-p/12835897#M15077 <P>I am trying to figure out how to chamfer the edge of a part after machining a pocket or whatever. The chamfering tool follows its path but is too far from the edge to cut anything. Any tips?</P> Wed, 12 Jun 2024 20:55:53 GMT https://forums.autodesk.com/t5/fusion-support-forum/chamfering-trick-wanted/m-p/12835897#M15077 Jim_WrixonDXSZD 2024-06-12T20:55:53Z https://forums.autodesk.com/t5/fusion-support-forum/chamfering-trick-wanted/m-p/12835924#M15078 <P>Hi,</P> <P>please share a file for reply</P> <P>File &gt; export &gt; save as f3d on local drive &gt; attach to post</P> <P>&nbsp;</P> <P>günther</P> Wed, 12 Jun 2024 21:10:57 GMT https://forums.autodesk.com/t5/fusion-support-forum/chamfering-trick-wanted/m-p/12835924#M15078 g-andresen 2024-06-12T21:10:57Z https://forums.autodesk.com/t5/fusion-support-forum/chamfering-trick-wanted/m-p/12837974#M15079 <P>Is there a place to put this file?</P> Thu, 13 Jun 2024 17:04:19 GMT https://forums.autodesk.com/t5/fusion-support-forum/chamfering-trick-wanted/m-p/12837974#M15079 Jim_WrixonDXSZD 2024-06-13T17:04:19Z