https://forums.autodesk.com/t5/fusion-support-forum/spiral-taper-roller-conveyor/m-p/12836707#M15075 <P>Unwrap and Flat Patterns each require a flat piece (sometimes a dummy face)</P><P>Modify the roller to have a small air gap / seam, add an overly small flat face to the roller, and unwrap Flat Patterns will work.</P><P>&nbsp;</P><P>&nbsp;</P><P>Might help….</P><P>&nbsp;</P><P>&nbsp;</P> Thu, 13 Jun 2024 07:59:33 GMT davebYYPCU 2024-06-13T07:59:33Z https://forums.autodesk.com/t5/fusion-support-forum/spiral-taper-roller-conveyor/m-p/12836260#M15074 <P>Hi, any help or advice as how to create a Sheetmetal (and flat pattern) part for a spiral taper roller conveyor side (inner and outer sides) in Fusion? Please see attached pictures.</P> Thu, 13 Jun 2024 01:19:12 GMT https://forums.autodesk.com/t5/fusion-support-forum/spiral-taper-roller-conveyor/m-p/12836260#M15074 LIBBIT_DESIGN 2024-06-13T01:19:12Z https://forums.autodesk.com/t5/fusion-support-forum/spiral-taper-roller-conveyor/m-p/12836707#M15075 <P>Unwrap and Flat Patterns each require a flat piece (sometimes a dummy face)</P><P>Modify the roller to have a small air gap / seam, add an overly small flat face to the roller, and unwrap Flat Patterns will work.</P><P>&nbsp;</P><P>&nbsp;</P><P>Might help….</P><P>&nbsp;</P><P>&nbsp;</P> Thu, 13 Jun 2024 07:59:33 GMT https://forums.autodesk.com/t5/fusion-support-forum/spiral-taper-roller-conveyor/m-p/12836707#M15075 davebYYPCU 2024-06-13T07:59:33Z