topic Re: Reproducible crash with Coil tool (project attached) in Fusion Support Forum

Reproducible crash with Coil tool (project attached)

Hamid_M — Sun, 16 Jun 2024 18:16:08 GMT

With the attached project open (CoilCrash2):
1. Select SOLID -> CREATE -> Coil
2. (You are asked to "Select the geometry or profile..") Select the top surface of the component
3. (You are asked to "Place center point") Try to select anything including sketch points or curves and note that no point or curve turns blue as you hover above them (don't click the mouse button, just try to select, and note that you can't select any existing geometry and give up)
4. Go to SOLID -> SELECT -> Selection Priority, and notice all menu items are greyed out
5. Go to SOLID -> SELECT -> Selection Filters, and unselect Sketch Curves and observe application crash after 2 or 3 seconds.

Fusion 2.0.19440 arm64 [Native]
macOS 14.5 (23F79) on MacBookPro18,2

Re: Reproducible crash with Coil tool (project attached)

jhackney1972 — Sun, 16 Jun 2024 20:52:05 GMT

I am using a Windows computer and I do not see any issue. When you are asked to select the center of the coil, you need to select the projected origin and then you select the profile you want to match to.

Re: Reproducible crash with Coil tool (project attached)

Hamid_M — Sun, 14 Jul 2024 16:59:13 GMT

Hi, I can still recreate the crash, I've attached a video below:

(view in My Videos)

Re: Reproducible crash with Coil tool (project attached)

Hamid_M — Sun, 14 Jul 2024 16:59:50 GMT

I've attached a video of the crash