topic Re: Problem with share links. in Fusion Support Forum

Problem with share links.

HughesTooling — Thu, 25 Apr 2019 18:38:06 GMT

Whenever I click a share link in a post, for example this post. I get this page and don't seem to have any option to view the shared part.

I can view my own links but any I've tried on the forum don't work.

Mark

Re: Problem with share links.

ryan.bales — Thu, 25 Apr 2019 22:01:50 GMT

I'm seeing the same thing but i'm not sure. @karina.harper and i passed some links to eachother not via forums and its working just fine.

Here is another test: https://a360.co/2PwBjui

Re: Problem with share links.

HughesTooling — Thu, 25 Apr 2019 22:28:09 GMT

At home now and I can view the design you linked and the one from the thread I linked to above so not sure if it's something that was a temporary problem. I'll check again tomorrow at work.

Thanks Mark

Re: Problem with share links.

HughesTooling — Fri, 26 Apr 2019 12:08:22 GMT

@ryan.bales Back at work and can't view your share like or any others. One thought is I've blocked several urls in my router to stop adds and other junk, don't suppose any of these are needed? Other than that the only difference between home and work is the ISP.

Mark

Re: Problem with share links.

ryan.bales — Fri, 26 Apr 2019 13:49:45 GMT

I would not block amazonaws. That is likely the sole culprit. Have a look here:

https://knowledge.autodesk.com/support/fusion-360/troubleshooting/caas/sfdcarticles/sfdcarticles/Fusion-360-cannot-access-the-services-through-proxy.html

Re: Problem with share links.

HughesTooling — Fri, 26 Apr 2019 14:41:44 GMT

I'm pretty sure I blocked it because of annoying adds so I'll just have to put up with no share links. Think I had some problems with dodgy adds on eBay redirecting to other sites and there's no way to report to eBay. Some info here.

Mark