topic Re: Edge selection set appears to not be working in Fusion Support Forum

Edge selection set appears to not be working

dagroenewald — Sun, 12 May 2019 02:00:56 GMT

After selecting a number of edges in my model and saving as a selection set I can seem to reselect the set of edges by clicking on the selections sets Select menu option. Can anyone confirm this is working for them.

Re: Edge selection set appears to not be working

pawel.potyrala — Sun, 12 May 2019 11:01:47 GMT

Hello @dagroenewald,

thanks for posting!

I just tested the following workflow and cannot seem to reproduce the issue:

Go to Select -> Selection Filters
Disable all options but Body Edges
Select a number of Body Edges
Right-click and Create Selection Set
Re-select the set of edges from within the browser tree.

Here's a screencast:

Is that the workflow that fails for you? Can you make sure that the top component (or a correct component) is activated? If this persists, could you record a short screencast presenting your workflow?

Thanks in advance!

Best regards,

Re: Edge selection set appears to not be working

dagroenewald — Mon, 13 May 2019 02:06:47 GMT

Thanks for the response - yes that appears to be the same workflow although I don't have a component just a body on which I am selecting the edges.

The selection seems to show the correct count of the edges. Not sure I know how to do a screen cast to send you.

Re: Edge selection set appears to not be working

pawel.potyrala — Mon, 13 May 2019 08:33:41 GMT

Hi @dagroenewald,

thanks for the reply! I just tried this for bodies - it works just as it worked for the components.

Here's an instruction on how to record a screencast:

How to use Autodesk Screencast to document a support issue

Thanks!

Best regards,