https://forums.autodesk.com/t5/fusion-support-forum/error-when-trying-to-inset-angled-circular-face/m-p/13415081#M1455 <P>I can't figure out how to inset this face (see images) by ~1mm. I tried using Offset Face but get this error:</P><P>&nbsp;</P><P>Error: The operation could not create a valid result.<BR />Try adjusting the values or changing the inputs.</P><P>&nbsp;</P><P>The model was an imported mesh but it has been converted to a body and the face I'm trying to inset was created by cutting out a cylinder so its a clean surface. Anyone know why this won't work?</P> Tue, 08 Apr 2025 16:13:26 GMT Spyro-JoKeR 2025-04-08T16:13:26Z https://forums.autodesk.com/t5/fusion-support-forum/error-when-trying-to-inset-angled-circular-face/m-p/13415081#M1455 <P>I can't figure out how to inset this face (see images) by ~1mm. I tried using Offset Face but get this error:</P><P>&nbsp;</P><P>Error: The operation could not create a valid result.<BR />Try adjusting the values or changing the inputs.</P><P>&nbsp;</P><P>The model was an imported mesh but it has been converted to a body and the face I'm trying to inset was created by cutting out a cylinder so its a clean surface. Anyone know why this won't work?</P> Tue, 08 Apr 2025 16:13:26 GMT https://forums.autodesk.com/t5/fusion-support-forum/error-when-trying-to-inset-angled-circular-face/m-p/13415081#M1455 Spyro-JoKeR 2025-04-08T16:13:26Z https://forums.autodesk.com/t5/fusion-support-forum/error-when-trying-to-inset-angled-circular-face/m-p/13415561#M1456 <P>When offsetting a surface, Fusion needs to extend, or trim the triangular faces bordering that surface. That fails as there isn't a large enough surface to extend/trim.</P> Tue, 08 Apr 2025 21:15:20 GMT https://forums.autodesk.com/t5/fusion-support-forum/error-when-trying-to-inset-angled-circular-face/m-p/13415561#M1456 TrippyLighting 2025-04-08T21:15:20Z