topic Re: Editing extrusions and workplanes WITHOUT access to history/timeline bar in Fusion Support Forum

Editing extrusions and workplanes WITHOUT access to history/timeline bar

Anonymous — Sat, 26 Oct 2019 13:15:13 GMT

Can this be done?

If I enable it, should it show features I have made when it wasn't enabled?

Re: Editing extrusions and workplanes WITHOUT access to history/timeline bar

TheCADWhisperer — Sat, 26 Oct 2019 13:16:56 GMT

You can use Direct Editing techniques without timeline.

If you enable Capture Design History - you will capture only history from that point on.

Re: Editing extrusions and workplanes WITHOUT access to history/timeline bar

Anonymous — Sat, 26 Oct 2019 13:48:26 GMT

So there's no way at all? Golly, that is rather sucky.

Thanks anyway.

Re: Editing extrusions and workplanes WITHOUT access to history/timeline bar

jeff_strater — Sat, 26 Oct 2019 15:57:06 GMT

You might have missed this from @TheCADWhisperer : "You can use Direct Editing techniques without timeline." There is quite a bit of editing that you can doin Direct Modeling. Press/Pull on end and side faces of an Extrude, and you can use Move to re-position a workplane (which you cannot do in timeline mode). Those editing techniques are not as powerful as parametric editing, but when you don't have a parametric design, you can't expect the power of parametric edit.