topic Re: Sweep multiple lines in Fusion Support Forum

Sweep multiple lines

VGBenjamin — Thu, 07 Nov 2019 14:15:44 GMT

Hello,

I would like to sweep my little triangle (v-carve) alone all the lines of my little triangle to join each holes. I am able to create the round path but I am not able to select

But when I try to select more line I have the following message:

How could I create this carve everywhere?

Regards,

Benjamin

Re: Sweep multiple lines

wmhazzard — Thu, 07 Nov 2019 14:53:46 GMT

The path will not sweep with multiple intersections. You will have to create profiles on every inside line and sweep them separately. You should be able to copy and paste the sketch profile onto new planes along the paths.

Re: Sweep multiple lines

laughingcreek — Thu, 07 Nov 2019 16:37:25 GMT

see attached. this builds on the way @etfrench was doing it in the previous thread. I used the pipe command to do the cut, instead of a sweeped cut. but it's only done 3 times, so adding a profile on a "plane along path" and sweeping 3x times shouldn't be to bad.