topic Re: Fusion CAM - Radius problem in Fusion Support Forum

Fusion CAM - Radius problem

schmidt_be — Fri, 28 Feb 2020 03:31:16 GMT

Hi there, any help is very much appreciated. I have a large CNC machine (Tekcel P2 Router). My jobs simulate in Fusion fine, however on the machine it cut's the radius incorrectly. Link to photo here:

https://woodcroftcollege-my.sharepoint.com/:i:/g/personal/schmidt_be_woodcroft_sa_edu_au/EYP-CYQSK_BIlxWr2Z2vboYBZ667yBH7gjEYN5W3ySXBqQ?e=Bn6CRj

Link to Tekcel Post Processor here:

https://woodcroftcollege-my.sharepoint.com/:u:/g/personal/schmidt_be_woodcroft_sa_edu_au/EZcjKTJwZi9Mgp48N82CdVEBZ5inQNsPHNH1Li0vd6ibiA?e=LzhfN0

My knowledge of where to look in the post processor is limited. Anyone that can help will be my savior!

Thanks,

Ben.

Re: Fusion CAM - Radius problem

g-andresen — Tue, 03 Mar 2020 14:30:39 GMT

Hi Ben,

I think, a better place for this is the Manufacture Forum.

günther

Re: Fusion CAM - Radius problem

infoS89W5 — Fri, 23 Apr 2021 11:51:46 GMT

Hi, I've got the same problem. Tekcel K2, Did you get it sorted? If so, can you share 🙂

Re: Fusion CAM - Radius problem

TheCADWhisperer — Fri, 23 Apr 2021 11:59:51 GMT

@infoS89W5

https://forums.autodesk.com/t5/fusion-360-manufacture/bd-p/2070

Re: Fusion CAM - Radius problem

schmidt_be — Mon, 26 Apr 2021 08:43:24 GMT

I did have some success. By unchecking the output circular check box in the post properties, it resolved the issue. I then edited my post to have output circular to default to unchecked. I assume not the ideal solution but seemed to work. Hope that helps.

Cheers,

Ben.