topic Re: Possible Bug: Generating STL file in Fusion Support Forum

Possible Bug: Generating STL file

vex — Tue, 14 Apr 2020 20:00:03 GMT

It appears I am now unable to generate an STL file for saving (either by right clicking the body and selecting save stl, or by unchecking send to slicer), but I am able to directly send the mesh data to the slicing software.

There does not appear to be any predefined processes that would trigger this. Geometry is relatively simple with no ill defined features from what I can see.

Re: Possible Bug: Generating STL file

tallisb — Tue, 14 Apr 2020 20:37:56 GMT

Hello Vex-

Is it possible for you to share your model?

I just tried it with one of mine and it worked just fine.

Also, make sure your model is a valid model and not an "open mesh", such as faces missing, intersecting faces, etc.

Brad

Re: Possible Bug: Generating STL file

vex — Tue, 14 Apr 2020 22:36:01 GMT

Unfortunately I am unable to share that specific model--but it does not appear to be model specific so any other I provide may suffice the same. The most recent report can be found at: CER_217617073

This behavior appears to occur regardless of model and may be an issue with my particular hard/software (dual display, Radeon 7870HD Ghz Edition).

I'm just spitballing at this point: But could it be a problem between Cura 4.5 and Fusion?

Re: Possible Bug: Generating STL file

JeromeBriot — Wed, 15 Apr 2020 09:28:55 GMT

Hello,

You could try with my free add-in 3D Print Plus.