topic Re: Problems with opacity in Fusion Support Forum

Problems with opacity

Rob_Ellis — Thu, 16 Apr 2020 23:57:03 GMT

So I have a vise with stock setup to be driven with parameters. I have my stock body set to 50% opacity. It works completely fine, however recently I have run into an issue where whenever I joint a part to my stock, the opacity control goes away and I can't see my part. Of course, I can turn off the stock body which is my current workaround, but obviously I want to find out where my issue is so I can fix it. I may be doing something wrong, but this wasn't an issue until recently.

I do keep my drivers up to date, and even updated to the newest one as of today just to make sure.

I'm uploading a screencast right now, I will post it if needed and when its done uploading.

Re: Problems with opacity

jeff_strater — Fri, 17 Apr 2020 00:08:48 GMT

There seems to be a graphics problem that is being worked on. See this thread: opacity-control-not-working , which contains a workaround.

Re: Problems with opacity

Rob_Ellis — Fri, 17 Apr 2020 01:11:36 GMT

That makes me feel better that I wasn't doing something wrong. haha. Thanks for the info!