https://forums.autodesk.com/t5/fusion-support-forum/not-generating-tool-paths/m-p/9538794#M113140 <P>&nbsp;&nbsp; I am running a part and needed to change a dimension locating some hole patterns, I edited the sketch, everything took and I saved the model. I then proceeded to manufacturing tab to regenerate the tool paths to re post programs and low and behold, tool paths will not generate for drilling and threading. I have heard this was a problem and I nave not had an issue until today.&nbsp;</P> Mon, 25 May 2020 19:56:21 GMT jameswyatthopkins 2020-05-25T19:56:21Z https://forums.autodesk.com/t5/fusion-support-forum/not-generating-tool-paths/m-p/9538794#M113140 <P>&nbsp;&nbsp; I am running a part and needed to change a dimension locating some hole patterns, I edited the sketch, everything took and I saved the model. I then proceeded to manufacturing tab to regenerate the tool paths to re post programs and low and behold, tool paths will not generate for drilling and threading. I have heard this was a problem and I nave not had an issue until today.&nbsp;</P> Mon, 25 May 2020 19:56:21 GMT https://forums.autodesk.com/t5/fusion-support-forum/not-generating-tool-paths/m-p/9538794#M113140 jameswyatthopkins 2020-05-25T19:56:21Z https://forums.autodesk.com/t5/fusion-support-forum/not-generating-tool-paths/m-p/9538835#M113141 <P><EM>&nbsp; &nbsp; I need to post an update to this problem. It seems that when I edited the model, the cam geometry was lost. evidently if the geometry moves too far the cam side of the software will lose the geometry. I must have broken the threshold on the distance this time. Sorry, goes to show how much humans are habitual.&nbsp;</EM></P> Mon, 25 May 2020 19:59:22 GMT https://forums.autodesk.com/t5/fusion-support-forum/not-generating-tool-paths/m-p/9538835#M113141 jameswyatthopkins 2020-05-25T19:59:22Z