topic Re: Fusion not generating tool path correctly. in Fusion Support Forum

Fusion not generating tool path correctly.

Anonymous — Tue, 26 May 2020 20:42:53 GMT

I am trying to use Fusion 360 for a personal CNC plasma table setup I have at home. When I try to set the cut paths for the design, Fusion doesn't allow me to set the cut paths in the proper place for cuts on the interior of the piece. If I am trying to cut, let's say, an interior hole on a plate, the red arrow that shows the starting point of the hole is well outside of the hole, and even when I click on the arrow to change it's location, it doesn't help. Sometimes it makes it worse. Is there something set wrong in my setup? Is there an offset number or something somewhere that needs changes? Any help with this issue would be greatly appreciated, as I have done everything I know to do to correct the issue.

Thank you

Re: Fusion not generating tool path correctly.

jhackney1972 — Tue, 26 May 2020 20:49:33 GMT

Would it be possible to attach your model?

Re: Fusion not generating tool path correctly.

Anonymous — Thu, 28 May 2020 12:19:39 GMT

Sure. The drawing is attached.

Re: Fusion not generating tool path correctly.

Anonymous — Thu, 28 May 2020 12:20:54 GMT

The only way it would allow me to upload the drawing was to upload the .dwg. I couldn't upload the .dxf file, and I don't have access to my Fusion 360 here at work. Hope this helps.