topic Re: Remove small circles in Fusion Support Forum

Remove small circles

Anonymous — Fri, 17 Jul 2020 01:08:20 GMT

trying to remove little circles on a Fusion 360 sketch

Re: Remove small circles

jeff_strater — Fri, 17 Jul 2020 01:48:41 GMT

those are not "circles", they are sketch points (most likely center points from arcs). You cannot delete them, but you can turn off their display here:

Re: Remove small circles

Anonymous — Fri, 17 Jul 2020 01:53:30 GMT

ok, I clicked on show points and then finish sketch and nothing happened

Re: Remove small circles

jeff_strater — Fri, 17 Jul 2020 02:01:45 GMT

you'll have to share the design here. When you say "small circles" are these what you are talking about?

Re: Remove small circles

Anonymous — Fri, 17 Jul 2020 02:03:04 GMT

yes, all those little dots

Re: Remove small circles

jeff_strater — Fri, 17 Jul 2020 02:11:18 GMT

see this article: How-to-share-a-Fusion-360-design and export your design as an F3D and attach it here. I can take a look at the design.

Re: Remove small circles

Anonymous — Fri, 17 Jul 2020 02:22:25 GMT

how do I attach my F3D file?

Re: Remove small circles

Anonymous — Fri, 17 Jul 2020 02:27:55 GMT

http://a360.co/3eFWt4e

Re: Remove small circles

Anonymous — Fri, 17 Jul 2020 02:33:13 GMT

I'll get back tomorrow, I've off to bed. thanks

Re: Remove small circles

jeff_strater — Fri, 17 Jul 2020 02:41:27 GMT

you just have a lot of sketches in this design. This may cause other problems down the road, or it may not. But, the "Show Points" setting is applied per sketch, so you just have to find all the sketches which have points in them, and turn them off:

Re: Remove small circles

Anonymous — Fri, 17 Jul 2020 18:46:39 GMT

thanks so much, one thing I was skipping the right click and edit sketch moves. Phil