topic Re: Post Process Output Folder resets when restarting Fusion in Fusion Support Forum

Post Process Output Folder resets when restarting Fusion

matth — Thu, 06 Aug 2020 14:57:33 GMT

The software used to remember the last location posted to, now it does it but for only the session. Since last update.

Re: Post Process Output Folder resets when restarting Fusion

peterson1979 — Fri, 07 Aug 2020 14:59:49 GMT

I'm seeing the same thing @matth. Hopefully they figure this out because it's a little annoying.

Re: Post Process Output Folder resets when restarting Fusion

Anonymous — Fri, 21 Aug 2020 12:42:36 GMT

I am also experiencing this issue and I hope it gets fixed soon. @keqingsong

Re: Post Process Output Folder resets when restarting Fusion

fozzy — Sat, 29 Aug 2020 21:18:47 GMT

This is unbelievably annoying.

Searching for the problem is also kinda hard. There are quite a few reports of the same thing, but worded differently, and i think the issue might be getting ignored because of it.

PLEASE fix this.

Re: Post Process Output Folder resets when restarting Fusion

HughesTooling — Sat, 29 Aug 2020 21:31:09 GMT

I reported the problem a few weeks ago in the manufacture forum here. @seth.madore acknowledged the problem, but no fusion bug report number so not sure it;s being tracked.

Mark

Re: Post Process Output Folder resets when restarting Fusion

seth.madore — Sun, 30 Aug 2020 22:48:45 GMT

It is being tracked as CAM-23980. It was logged within an hour or being discovered, sorry, I should have posted back.

Good news though; I think the last internal Staging build has this issue addressed. That doesn't tell us anything about WHEN the fix will come out, but just that there IS one.