topic Problems with sheet metal in Fusion Support Forum

Problems with sheet metal

Anonymous — Sun, 23 Aug 2020 07:32:53 GMT

Have arisen problems with sheet metal, especially when using the LOFT command.

In some cases, I cannot execute the THICKNESS command for the built surface

In other cases, conversion to sheet metal fails

Finally, if these two stages can be overcome, the Flat Pattern often fails

I hope you can give me some advice.

Thanks in advance.

Sincerely, Victor

Anonymous — Sun, 23 Aug 2020 07:34:59 GMT

Added files:

TheCADWhisperer — Sun, 23 Aug 2020 11:15:12 GMT

@Anonymous wrote:
I hope you can give me some advice.

~~Can you File>Export your *.f3d file to your local drive and then Attach it here to a Reply?~~

Your sides are twisted.

You must use Autodesk Inventor Professional - Lofted Flange.

Fusion 360 only supports planar faces with cylindrical or conic bends - no twisted faces.