topic Re: offset from offset issue in Fusion Support Forum

offset from offset issue

g-andresen — Fri, 27 Sep 2024 09:45:22 GMT

Hi,

After the update, I was able to test this new option twice.
I have been getting an error message for a few days now.

(view in My Videos)

Does anyone have any idea what could be causing this?

günther

Re: offset from offset issue

HughesTooling — Fri, 27 Sep 2024 10:17:31 GMT

It looks like you need to enable Match Topology on the offset dialog when you create the first offset. Not very helpful if you've created the offset then later need to offset from the offset!

Re: offset from offset issue

HughesTooling — Fri, 27 Sep 2024 10:27:49 GMT

Just noticed you can double click the offset icon to bring up the offset dialog again but the option to match topology is greyed out! You can change to 2 sided but not match topology which is a shame. @jeff_strater Is this something that can be improved?

Re: offset from offset issue

sameer_babarNJS6C — Fri, 27 Sep 2024 13:31:07 GMT

@g-andresen @HughesTooling

For now ,Offset of offset is allowed for the offset's created with Match topology turned ON.

Thanks & Regards,
Sameer Babar.

Re: offset from offset issue

g-andresen — Fri, 27 Sep 2024 13:33:19 GMT

Hi,

Many thanks for the tips.
However, I don't think that either method is user-friendly.

günther

Re: offset from offset issue

sameer_babarNJS6C — Fri, 27 Sep 2024 13:35:37 GMT

@g-andresen Thanks for your feedback, definitely these limitations will be removed in future development.

Regards,
Sameer Babar.

Re: offset from offset issue

crueby1 — Fri, 27 Sep 2024 13:36:37 GMT

For now ,Offset of offset is allowed for the offset's created with Match topology turned ON.

Thanks & Regards,
Sameer Babar."

So, will this be changed in the future to allow it for any offset??

Re: offset from offset issue

sameer_babarNJS6C — Fri, 27 Sep 2024 13:40:05 GMT

Yes, this is in plan of next offset improvement.

Thanks & Regards,
Sameer Babar.

Re: offset from offset issue

Phil.E — Wed, 16 Jul 2025 16:43:18 GMT

This has been addressed in this week's update.