topic Re: Why Fusion 360 can't make programs without cuts? in Fusion Manufacture Forum

Why Fusion 360 can't make programs without cuts?

Anonymous — Sat, 12 Oct 2019 15:33:05 GMT

I’ve been trying to work with Fusion 360 for a whole year and there is always the same problem - the Fusion 360 makes cuts during rest machining.

This problem appears 1-2 times per a month, but not always I manage to notice it and I have to throw out the some parts.

So - why Fusion 360 can't make programs without cuts?

This problem is constantly present for a whole year and no one is going to fix it.

Re: Why Fusion 360 can't make programs without cuts?

seth.madore — Sat, 12 Oct 2019 15:35:18 GMT

That's certainly not a desirable result. Can you share your a360 link to it? If you don't want to post it publicly, email it to me at: seth dot madore at autodesk.com

Re: Why Fusion 360 can't make programs without cuts?

Anonymous — Sat, 12 Oct 2019 16:08:14 GMT

Yes, i can.

How can i do it ?

May be this ? -

https://myhub.autodesk360.com////

Re: Why Fusion 360 can't make programs without cuts?

seth.madore — Sat, 12 Oct 2019 16:06:55 GMT

Right click on the file in the Data Panel and click "Share A360 link"

Re: Why Fusion 360 can't make programs without cuts?

Anonymous — Sat, 12 Oct 2019 16:27:41 GMT

here it - https://a360.co/2IF8lq7

problem only with toolpath with name "Rough 2"

Re: Why Fusion 360 can't make programs without cuts?

seth.madore — Mon, 14 Oct 2019 14:59:26 GMT

I believe this is being caused by your extra 100mm offset on your geometry tab. Removing that value gives us a toolpath that doesn't gouge.

I will note that the gouge DOES show up in the simulation, especially in "Standard" sim quality. I tend to avoid the "Fast-3 axis" because it does a very poor job of representing what's actually going to be the resulting part.