topic Re: Blend, allowance Bug. in Fusion Manufacture Forum

Blend, allowance Bug.

HughesTooling — Wed, 23 Oct 2019 12:06:20 GMT

It seems like blend is adding the axial allowance to the radial allowance and leaving twice as much on the sides. I've set both to 0.2mm and it's correct on the depth but you can see in the image below where the part on the right is done with parallel there's a step at the corner where blend takes over. I've attached the file. It seems that setting the radial allowance to 0 and the axial to 0.2mm give 0.2mm on the sides and bottom like I need.

Thanks Mark

Re: Blend, allowance Bug.

HughesTooling — Thu, 24 Oct 2019 16:01:27 GMT

@seth.madore Any thought on this one before it drops of the first page.

Thanks Mark

Re: Blend, allowance Bug.

seth.madore — Thu, 24 Oct 2019 16:10:26 GMT

Sorry about that Mark, I'll dig into it. Been a busy week for me

(that is starting to sound like a broken record....)

Re: Blend, allowance Bug.

seth.madore — Sat, 26 Oct 2019 20:50:34 GMT

I've logged this as CAM-18055. I'll post back here when/if there is anything more to add. Thanks for bringing this to our attention!