topic Re: Allow three selections in Partial Boss Probing - IDEA in Fusion Manufacture Forum

Allow three selections in Partial Boss Probing - IDEA

da_fish — Wed, 23 Oct 2024 21:42:19 GMT

When I am using "XY Circular Partial Boss" probing in Fusion, the circular surface is most times not connected. For example:

I would like to be able to select three surfaces and use that for probing. For example:

But as you can see, when I select three surfaces Fusion doesn't like that, and the probe type is unspecified.

If I select one surface, then it won't let me drag the points off of that surface:

The only way to get a round this is the create a patch surface and use that as the probe surface, which is what I did in the first picture.

p.s. I was going to post this to the Idea board but I couldn't fine the Fusion category. I hope this is the right place to post this.

Re: Allow three selections in Partial Boss Probing - IDEA

da_fish — Wed, 18 Sep 2024 12:54:49 GMT

Is this the right place to post ideas?

Re: Allow three selections in Partial Boss Probing - IDEA

Linus_Follinger — Thu, 19 Sep 2024 05:18:33 GMT

I wonder that myself.
it would be nice with a seperate page for ideas.
and where you can vote 1 to 10 on existing posts to see what the community wants the moast