https://forums.autodesk.com/t5/fusion-manufacture-forum/probing-wcs-not-working-on-extended-offsets/m-p/11341007#M43925 <P>Just ran into a situation with our Haas VF5SS. Normally we probe our WCS with normal offsets G54-G59. We did a part the other day and did G54.1P19. The probe went through the function but did not update the work offset. If I switch back to G54-G59, it is fine. Does it only work on the standard offsets?</P> Thu, 04 Aug 2022 21:57:15 GMT vpace91423 2022-08-04T21:57:15Z https://forums.autodesk.com/t5/fusion-manufacture-forum/probing-wcs-not-working-on-extended-offsets/m-p/11341007#M43925 <P>Just ran into a situation with our Haas VF5SS. Normally we probe our WCS with normal offsets G54-G59. We did a part the other day and did G54.1P19. The probe went through the function but did not update the work offset. If I switch back to G54-G59, it is fine. Does it only work on the standard offsets?</P> Thu, 04 Aug 2022 21:57:15 GMT https://forums.autodesk.com/t5/fusion-manufacture-forum/probing-wcs-not-working-on-extended-offsets/m-p/11341007#M43925 vpace91423 2022-08-04T21:57:15Z https://forums.autodesk.com/t5/fusion-manufacture-forum/probing-wcs-not-working-on-extended-offsets/m-p/11341328#M43926 <P>What post were you using?</P><P>&nbsp;</P><P>HAAS nomenclature for additional WCS however is "G154.XX" so I suspect there is an issue potentially in specifying</P><P>&nbsp;</P><P>Can you post the Gcode or a picture? The key string here will be the S value on the G65 callout</P> Fri, 05 Aug 2022 03:02:10 GMT https://forums.autodesk.com/t5/fusion-manufacture-forum/probing-wcs-not-working-on-extended-offsets/m-p/11341328#M43926 rengfx 2022-08-05T03:02:10Z