topic Re: Blend fail in Fusion Manufacture Forum

Blend fail

kretallick144 — Tue, 28 Jan 2025 12:51:17 GMT

Doing a few Blend toolpaths to produce a radius on a part.

All except one are fine. I have tried everything i can think of to get it working but no luck.

Its a straight area so nothing too complex.

Blend 45, either errors out or sits there calculating forever with no result.

Any ideas how to solve.

Unable to upload the file.

Re: Blend fail

FrodoLoggins — Tue, 28 Jan 2025 13:33:12 GMT

Recently I had blend fail to generate. I played with the stepover values. Went down to .001". Generated. Then I could choose whatever stepover I wanted even those that didn't work prior.

Re: Blend fail

seth.madore — Tue, 28 Jan 2025 13:39:09 GMT

Unable to upload file? Is that because it's private or that the forums are being a pain and not letting you?

Re: Blend fail

kretallick144 — Tue, 28 Jan 2025 14:15:09 GMT

Hi Seth,

Forum is being a pain! i have been able to load anything in the format desired for a while.

Re: Blend fail

seth.madore — Tue, 28 Jan 2025 14:18:13 GMT

Dump the file into a .ZIP folder and attach that here

Re: Blend fail

kretallick144 — Tue, 28 Jan 2025 14:19:47 GMT

OK, i tried a small stepover and it sort of worked.

Instead of being a nice smooth back and forth path its all over the place. Like it is starting from a central point.

Other Radius's are fine, and were drawn all at the same time, covering the top edge of the model.