topic "The output folder for the selected NC program could not be created." in Fusion Manufacture Forum

"The output folder for the selected NC program could not be created."

kanleeD9CMZ — Fri, 24 Feb 2023 05:21:31 GMT

I'm relatively new to cam machining. I've done around 100+ programs so far on Fusion 360.

I've just finished my most involved part with 8 set-ups and 48 operations.

I went to post process the operations and set up under my first set-up and the error message above appeared.

First time I've seen this.

Re: "The output folder for the selected NC program could not be created."

seth.madore — Fri, 24 Feb 2023 08:23:06 GMT

Were you posting code to a USB drive that was disconnected? Can you share a screenshot of your posting dialog?

Re: "The output folder for the selected NC program could not be created."

kanleeD9CMZ — Fri, 24 Feb 2023 21:18:58 GMT

Hi,

I get the following fault see attachment. I even tried to open up previous files that I had produced g-codes and machined the part before. I get the same fault on the

old file. I'm setting up the jobs as always, same machine, etc...

thanks,

Kan

Re: "The output folder for the selected NC program could not be created."

kanleeD9CMZ — Fri, 24 Feb 2023 22:07:00 GMT

Hi,

I got the problem solved. The output folder was not specified on the post process window.

We had our computers worked on and settings got changed....

Thanks,

Kan