topic Re: using a different offset for my probing result file in Fusion Manufacture Forum

using a different offset for my probing result file

magdi_gomaa — Mon, 11 May 2026 08:00:27 GMT

Hi everyone,

I have a question regarding probing and WCS behavior in Fusion 360 on a Haas mill.

My machining setup has always been based on G54. All generated motion/toolpath coordinates are relative to G54, and my probing inspection results were also reported relative to G54.

Now I received a new drawing from a client where the datum is defined differently: the origin is located at the center of the first hole, which is 13 mm away from my G54 setup origin. (as shown in the pic)

What I want to achieve is:

Keep ALL machine motion/toolpath coordinates relative to G54
Keep the actual probing moves relative to G54
BUT output the probing/inspection results relative to another coordinate system, for example G55

I hope that my question is clear and hoping for a good answer

Betreff: using a different offset for my probing result file

magdi_gomaa — Tue, 12 May 2026 10:55:00 GMT

any ideas ?

Re: using a different offset for my probing result file

UTD7ZNYB — Fri, 15 May 2026 12:08:17 GMT

You can just probe the hole in G54, set G55 based on that, and then run the inspection in G55.

Re: Betreff: using a different offset for my probing result file

lauri_barnhart — Mon, 18 May 2026 19:28:54 GMT

Hello @magdi_gomaa, we appreciate you posting your question.

Did the post by UTD7ZNYB help you and answer your question?

If this fixes the issue, please go ahead and accept it as the solution.

This ensures others can benefit from the resolution shared here.

If you still require support, please post an update so we can assist you further.

Regards,