topic Re: Machine builder haas ST10-Y in Fusion Manufacture Forum

Machine builder haas ST10-Y

crepin.baptiste — Fri, 10 Dec 2021 05:23:31 GMT

Hi,

I try to build the a four axis lathe , haas ST10-Y (XYZ - C)

But the X axis is not perpendicular to Y.

How can'I set it in machine builder configuration ?

Thanks

Re: Machine builder haas ST10-Y

boopathi.sivakumar — Fri, 10 Dec 2021 15:14:58 GMT

Hi @crepin.baptiste

Currently machine simulation / machine builder don't have support for turnmill machines.

Re: Machine builder haas ST10-Y

engineeringQCQFN — Sat, 11 Dec 2021 04:22:50 GMT

I'm looking forward to turning improvements, the machine builder is already released and it seems turning was forgotten, the gap between milling and turning is huge

Re: Machine builder haas ST10-Y

bruno.martyA5RNA — Fri, 04 Apr 2025 08:51:11 GMT

@boopathi.sivakumar

Do you if now in 2025, machine simulation for turn- milling mchine is available ? I have an HAAS ST10-Y and I want to simulate.

Thanks!

Re: Machine builder haas ST10-Y

seth.madore — Fri, 04 Apr 2025 10:00:53 GMT

No, but it's high on our list of priorities for upcoming development!

Re: Machine builder haas ST10-Y

marutishiv — Sat, 21 Jun 2025 14:52:22 GMT

It's 2025 and it is high time that the gap reduces between milling and turning capabilities of Fusion 360.

Re: Machine builder haas ST10-Y

joao_valerio2SAA3 — Wed, 12 Nov 2025 18:29:29 GMT

Where did you get the 3d model of your machine?

Re: Machine builder haas ST10-Y

programming2C78B — Wed, 12 Nov 2025 18:44:31 GMT