topic Re: Change to simulation? in Fusion Manufacture Forum

Change to simulation?

HughesTooling — Sat, 25 May 2024 10:08:37 GMT

In the past if you ran a simulation to the end then clicked the play button again it would start the simulation again with the original stock. Now if I do that the stock remains as the finished part, is that an intended change\improvement? Same problem if you click the go to previous operation.

Re: Change to simulation?

ktorokU233T — Sat, 25 May 2024 11:44:40 GMT

@HughesTooling

Check here in the sim control...

Re: Change to simulation?

HughesTooling — Sat, 25 May 2024 11:56:03 GMT

@ktorokU233T ~~Must have click that by mistake!~~ Didn't know that was an option. Edit. Just noticed it's the same on 2 PCs on different accounts so I guess set by an update.

Re: Change to simulation?

seth.madore — Sun, 26 May 2024 10:00:11 GMT

That's been in the software for a fair bit of time (I think January release). Not sure that we did anything to change the default settings 🤔

Re: Change to simulation?

HughesTooling — Sun, 26 May 2024 10:25:20 GMT

I had noticed it for quite a while but not that big a problem so I didn't ask before. I was working on some turning setups yesterday and you generally need a slower simulation compared to milling or it's finished before you can blink! So that's when I thought I'd ask. There was an update a couple of months ago that reset all my defaults on both PCs at work and my laptop so maybe that's when it changed.