https://forums.autodesk.com/t5/fusion-manufacture-forum/nc-corrector/m-p/7535779#M128821 <P>I have just downloaded NC Corrector to use as an NC Editor.&nbsp; Is there a way to change NC Corrector to display distance and feed rates from mm to inches?</P><P>Is this the best editor to use with Fusion 360 CAM?</P> Sat, 11 Nov 2017 01:53:52 GMT Anonymous 2017-11-11T01:53:52Z https://forums.autodesk.com/t5/fusion-manufacture-forum/nc-corrector/m-p/7535779#M128821 <P>I have just downloaded NC Corrector to use as an NC Editor.&nbsp; Is there a way to change NC Corrector to display distance and feed rates from mm to inches?</P><P>Is this the best editor to use with Fusion 360 CAM?</P> Sat, 11 Nov 2017 01:53:52 GMT https://forums.autodesk.com/t5/fusion-manufacture-forum/nc-corrector/m-p/7535779#M128821 Anonymous 2017-11-11T01:53:52Z https://forums.autodesk.com/t5/fusion-manufacture-forum/nc-corrector/m-p/7732793#M128822 <P>I don't use NC Corrector, but I am interested in your thought process in a quest to learn more.</P> <P>&nbsp;</P> <P>Are you using a controller that only works with inches and you have a .nc file that was created by someone else, using mm,</P> <P>and you wish to convert it for your machine?</P> <P>&nbsp;</P> <P>If&nbsp;it's your own content that you are posting to an .nc file,&nbsp;In F360, you can have your drawing be in inches or mm.</P> <P>When you post to create your .nc file,&nbsp;it will flag or allow you to flag the file as mm or inch (IIRC, F360 network is down at the moment)</P> <P>This should generate the proper G20/G21 (inch/mm) flag in the .nc file, for your&nbsp;controller to properly&nbsp;execute your code.</P> <P>&nbsp;</P> <P>The G20/21 code must match the coordinate info used after it.&nbsp;</P> <P>As far as I know, modern controllers don't give a darn if the code is in mm or inches,</P> <P>as long as it knows, it will run either way.</P> Mon, 29 Jan 2018 17:24:33 GMT https://forums.autodesk.com/t5/fusion-manufacture-forum/nc-corrector/m-p/7732793#M128822 k6ls 2018-01-29T17:24:33Z