topic Re: Changing Origin Size in Fusion EDA Schematics in Fusion Electronics Forum

Changing Origin Size in Fusion EDA Schematics

nsbernar — Sun, 29 May 2022 19:31:28 GMT

I have this library part https://www.snapeda.com/parts/EXB-D10C221J/Panasonic/view-part/?ref=digikey&welcome=home

But when I use it, the origin is either too small to show up or just is missing (see attached screenshot). You can see where the origin is in the library, but it's just basically missing from the schematic part. Any thoughts?

Re: Changing Origin Size in Fusion EDA Schematics

silvio3105 — Sun, 29 May 2022 20:27:48 GMT

Looks fine for me.

Origin is between 3 and 9

Turn on layer for origins(no 23).

Re: Changing Origin Size in Fusion EDA Schematics

nsbernar — Sun, 29 May 2022 20:46:03 GMT

As I noted, you can see it in the library editor. Have you tried placing the symbol?

Re: Changing Origin Size in Fusion EDA Schematics

silvio3105 — Mon, 30 May 2022 06:39:18 GMT

No, I'm not.
Check layer number 23. If it's off in schematic, then you cannot see origin and move component.
It should be on same spot where's in the lib(device).

Re: Changing Origin Size in Fusion EDA Schematics

yiqiu.han — Thu, 02 Jun 2022 08:25:55 GMT

Hi, @silvio3105

The 3rd party libraries you mentioned come from SnapEDA, they are not authorized by Autodesk. You could reach their website for more information.

Thanks,

Yiqiu

Re: Changing Origin Size in Fusion EDA Schematics

nsbernar — Fri, 03 Jun 2022 20:53:12 GMT

Thank you, I find that most of these are created by software and responses are few and far between regarding any issues with them. Thanks for your reply.