topic Re: FUSION 360 schematic net connection issue in Fusion Electronics Forum

FUSION 360 schematic net connection issue

yuzhou.lei — Mon, 03 Mar 2025 01:49:19 GMT

there are some warnings after I do the ERC check, which are "SEGMENT OF NET HAS TO VISUAL CONNECTION TO OTHER SEGMENT OF SAME NET"

the warnings:

what does this mean?

Re: FUSION 360 schematic net connection issue

yuzhou.lei — Mon, 03 Mar 2025 01:51:48 GMT

more inforamtion,

I checked the PCB, it looks ok.

Can I just approved these?

Re: FUSION 360 schematic net connection issue

yuzhou.lei — Mon, 10 Mar 2025 01:16:08 GMT

???

no one met this kind of """"issue before?

Re: FUSION 360 schematic net connection issue

constantin.popescuXD3CL — Mon, 10 Mar 2025 01:45:14 GMT

Hi @yuzhou.lei,

It most likely means that you haven't named the net segment explicitly (using a Net Label object) or there is no supply pin (VCC, GND, etc.) that would name the net automatically or the net segment is not connected to a bus. If you post a snapshot with where the issue is in your design I might be able to have a more precise answer.

I hope this helps.

Kind Regards,