topic Orientation of idents of components getting changed while all pcb layout rotate in Fusion Electronics Forum

Orientation of idents of components getting changed while all pcb layout rotate

anuradha.bodke — Fri, 01 Dec 2023 13:19:15 GMT

Hello Team,

I am making pcb file in fusion , when my design was finalized, I re arranged all idents of components neatly

now for preparing pcb panel, I need to rotate all pcb design in specific angle for adjusting proper panel size

While doing so all the idents of components are also getting rotated,

as per my understanding this will not tobe happened, idents are kept as it is

also share image for better understanding

this is individual pcb

this is pcb while rotating by angle 90 degree for panel purpose

Please if you can do, keep ident as it is after rotation of pcb layout

Thanks in Advance

Anuradha

Re: Orientation of idents of components getting changed while all pcb layout rotate

jorge_garcia — Fri, 01 Dec 2023 22:11:29 GMT

Hello @anuradha.bodke ,

I hope you're doing well. This is where you would use the spin flag on the text. By default the text always auto rotates to be "easily" readable. If you go into the properties you can check the spin flag for the text which will make sure it doesn't auto rotate.

Let me know if you continue to run into problems.

Best Regards,

Re: Orientation of idents of components getting changed while all pcb layout rotate

anuradha.bodke — Mon, 04 Dec 2023 05:02:24 GMT

Hello @jorge. garcia

That means if I don't want to rotate idents of components even though all pcb layout rotate. for so

I have to on spin command in property bar of all components

is it correct, because I don't want to change idents of components as I already arranged them

Please give reply

Thanks In Advance

Anuradha

Re: Orientation of idents of components getting changed while all pcb layout rotate

jorge_garcia — Mon, 04 Dec 2023 22:45:34 GMT

Hello @anuradha.bodke,

I hope you're doing well. Technically, you only have to set it on the texts that are rotated the wrong way but easiest to just set it for all of them.

Let me know if you continue to run into problems.

Best Regards,