https://forums.autodesk.com/t5/fusion-electronics-forum/need-help-with-pcb-design/m-p/12484701#M4162 <P>here is an additional file, in this one I drew lines representing how I think the traces should go. not all of the pins on the yellow connector are used and this ends up leaving pins on both connectors un used but I THINK this routing is the optimal one with the pins I actually need.</P> Tue, 09 Jan 2024 00:43:13 GMT supraman2jz 2024-01-09T00:43:13Z https://forums.autodesk.com/t5/fusion-electronics-forum/need-help-with-pcb-design/m-p/12482192#M4161 <P>Hi everyone,</P><P>&nbsp;</P><P>I am trying to design a harness adapter that will take the factory connector for my car and change it to a more standard connector. The PCB is very simple and only needs pads and traces to be connected to one another. the issue is I have never used the electronics design side of fusion 360 so I have no idea what I am doing. any help on this would be appreciated. here is a fusion model I whipped up showing what I am looking for but in a gerber file as well as a real one that exists but is different from the one I designed.</P><P>&nbsp;</P><P>&nbsp;</P> Sun, 07 Jan 2024 22:40:36 GMT https://forums.autodesk.com/t5/fusion-electronics-forum/need-help-with-pcb-design/m-p/12482192#M4161 supraman2jz 2024-01-07T22:40:36Z https://forums.autodesk.com/t5/fusion-electronics-forum/need-help-with-pcb-design/m-p/12484701#M4162 <P>here is an additional file, in this one I drew lines representing how I think the traces should go. not all of the pins on the yellow connector are used and this ends up leaving pins on both connectors un used but I THINK this routing is the optimal one with the pins I actually need.</P> Tue, 09 Jan 2024 00:43:13 GMT https://forums.autodesk.com/t5/fusion-electronics-forum/need-help-with-pcb-design/m-p/12484701#M4162 supraman2jz 2024-01-09T00:43:13Z