https://forums.autodesk.com/t5/fusion-electronics-forum/component-array-cannot-set-up-on-the-angles-i-need/m-p/12745380#M3018 <P>I managed to find a solution in the end. Instead of trying to place 36 components for 270 degrees, I placed 48 on 360 and then manually deleted the ones I didn't need. Then updated the schematic to link to the correct ones based on the placement in the 2D model.</P> Wed, 01 May 2024 07:17:32 GMT edneeves 2024-05-01T07:17:32Z https://forums.autodesk.com/t5/fusion-electronics-forum/component-array-cannot-set-up-on-the-angles-i-need/m-p/12738972#M3017 <P>I am slowly getting my head around Fusion 360 for Electronics. I am building a stepped attenuator and need help to understand how I can realign my array with the gap at the top (eg 45 degrees from 12 o'clock finishing a 315 degrees). Seem like Fusion treats the starting point as 3 o'clock and no matter how I play around with it, I cannot get the gap pointing up. There was a thread on here but the question was removed.</P><P>&nbsp;</P><P>And yes the segments are not the right shape. I haven't figured out how to make them wider at the top yet.</P> Sun, 28 Apr 2024 09:08:40 GMT https://forums.autodesk.com/t5/fusion-electronics-forum/component-array-cannot-set-up-on-the-angles-i-need/m-p/12738972#M3017 edneeves 2024-04-28T09:08:40Z https://forums.autodesk.com/t5/fusion-electronics-forum/component-array-cannot-set-up-on-the-angles-i-need/m-p/12745380#M3018 <P>I managed to find a solution in the end. Instead of trying to place 36 components for 270 degrees, I placed 48 on 360 and then manually deleted the ones I didn't need. Then updated the schematic to link to the correct ones based on the placement in the 2D model.</P> Wed, 01 May 2024 07:17:32 GMT https://forums.autodesk.com/t5/fusion-electronics-forum/component-array-cannot-set-up-on-the-angles-i-need/m-p/12745380#M3018 edneeves 2024-05-01T07:17:32Z