topic Re: Can SHOW to highlight a NET be used with multiple schematic Sheets? in Fusion Electronics Forum

Can SHOW to highlight a NET be used with multiple schematic Sheets?

chris_cummingsDT — Fri, 25 Jul 2025 19:21:33 GMT

It seems like when I am on a schematic sheet and use the Show command to highlight a complete Net, I lose the highlight as soon as I leave that sheet to go find the net on other sheets of a multi-sheet schematic.

Am I doing something wrong?

Re: Can SHOW to highlight a NET be used with multiple schematic Sheets?

chuck_toddN7PTC — Fri, 25 Jul 2025 20:01:21 GMT

@chris_cummingsDT

1) I have tried to highlight a net in the schematic using CRTL+SHIFT left click and see that it doesn't highlight on subsequent pages.

2) Show command doesn't seem to select the whole net either from the schematic.

3) I can highlight the net in the 2D PCB and then go back to the schematic where hyperlinks to the different pages are at the bottom left status bar.

4) I have tried highlighting a net using design manager filtering. As shown in the link below. This works, but not on signals that indicate active low with an explanation point at the beginning. (i.e. !RESET)

https://forums.autodesk.com/t5/fusion-electronics-forum/how-do-i-know-where-is-my-net-distributed-multiple-schemetic/m-p/9810642

BR -Chuck

Re: Can SHOW to highlight a NET be used with multiple schematic Sheets?

chris_cummingsDT — Fri, 25 Jul 2025 20:30:17 GMT

Thanks, @chuck_toddN7PTC ! I will try to see how number 3 works.