topic Re: DRC jumps to wrong position in Fusion Electronics Forum

DRC jumps to wrong position

jimUR4RG — Tue, 09 Feb 2021 13:49:03 GMT

When I click on a DRC error, the screen is supposed to jump to the position of the error. However, it jumps to the wrong position, quite far besides the board. This makes board design quite cumbersome as I now have to zoom out and manually zoom to each DRC error.

Does anyone else have this problem?

Re: DRC jumps to wrong position

engineeringNCMXB — Tue, 09 Feb 2021 17:10:22 GMT

I have not seen that problem.
Try turning on ALL layers before you run DRC. there may be something out there that is on a layer that is turned off.

Re: DRC jumps to wrong position

jorge_garcia — Tue, 09 Feb 2021 21:10:40 GMT

Hi @jimUR4RG ,

By any chance do you have the board flipped? If the board is flipped then the DRC error marks will point to the wrong location.

Let me know if there's anything else I can do for you.

Best Regards,

Re: DRC jumps to wrong position

jimUR4RG — Wed, 10 Feb 2021 08:57:28 GMT

Thanks Jorge, this solved my problem.