topic Re: Command Line Mode in Fusion Electronics Forum

Command Line Mode

VynxZ — Thu, 05 Dec 2024 23:58:18 GMT

Hello, Good Day, would like to ask from everyone here with regards to the command line mode in Fusion 360 Electronics. I'm using Autodesk EAGLE for electronics and when I shift to Fusion 360, I'm having a problem about the command line mode, like when I do Ctrl+D it will directly write down "Delete" in Command Line instead of doing the function. Unlike from EAGLE it will directly do the function. Would that be possible in Fusion 360 Electronics like how it works in EAGLE and how should I do it? Thank you very much.

Re: Command Line Mode

jorge_garcia — Fri, 06 Dec 2024 19:36:37 GMT

Hello @VynxZ,

I hope you're doing well. I'm not able to reproduce this, do you have a recording of the behavior? Just to make sure, the Electronics command line is on the top right. You can enter is by using the / command.

If you can post a recording then I can figure out what's going on.

Let me know if there's anything else I can do for you.

Best Regards,