topic Re: Polygon pours (RATSNEST) not automatically calculated. in Fusion Electronics Forum

Polygon pours (RATSNEST) not automatically calculated.

jesper8W75R — Sun, 27 Mar 2022 06:13:05 GMT

For some reason, the polygon ours are not automatically calculated as usual on my board.
I first noticed it when removing some holes I had on the board.
They were not refilled.
When moving a component, the old location is not refilled as can be seen with a resistor below.
Pushing violators work, but again, polygons are not updated.
I can do it manually, with the "Polygon->Refill Polygon Pours", but the old holes are still not filled.

Reported, Case ID 18862746

Re: Polygon pours (RATSNEST) not automatically calculated.

jorge_garcia — Mon, 28 Mar 2022 22:50:48 GMT

Hi @jesper8W75R ,

I hope you're doing well. Just on the off chance this setting has been disabled go into Preferences > Electronics Misc Tab. Make sure that Ratsnest process polygons is checked. Just a hunch on my part.

Best Regards,

Re: Polygon pours (RATSNEST) not automatically calculated.

jesper8W75R — Tue, 29 Mar 2022 01:32:26 GMT

Thanks Jorge,
This seems to have been a temporary bug.
After restarting Fusion, everything was okay.
I will try to see if I can recreate it.