topic Re: Doming the face of a triangle in Fusion Design, Validate & Document Forum

Doming the face of a triangle

tacop15 — Thu, 17 Dec 2020 05:31:42 GMT

I am drawing a triangular part. It is a cover for a triangle box. I want the part to be raised .150 from the edge of the part to the mounting bolt hole which is not quite in the center. Any ideas on how to go about this efficiently. I attached a pic of the old part that we are remaking.

Re: Doming the face of a triangle

jhackney1972 — Sat, 19 Dec 2020 00:04:43 GMT

You have given so little detail about your desired model, except a picture which is hard to pick off detail, I just made up some dimensioning to try and give you an example. You did not say if the cover was solid or hollowed out, I did the latter. The model is attached. If you find it does not meet your requirements, in method particularly, please "clearly" response with better specifications.

Re: Doming the face of a triangle

Ajay_Kumar_Reddy — Sat, 19 Dec 2020 02:21:41 GMT

To get the require hole at the center draw medians and locate the centre convert them into construction and use hole(h on keyboard) or create a circle and extrude the way you want.

Then you have mentioned about the 0.15. Just measure the distance and make sure the hole is in correct postion. If not just delete the construcion lines and move the hole to some distance using references(watch this video for setting the reference https://youtu.be/4rN9XY513O0?t=1318)