topic Re: Cannot Apply Face to Separate Component in Fusion Design, Validate & Document Forum

Cannot Apply Face to Separate Component

lukemaynes — Tue, 22 Dec 2020 20:20:47 GMT

Attempting to copy the face of the smaller component onto the top face of the larger component, shown below. I imported the smaller component from a separate file. I am trying to apply that face's design multiple times over the larger component.

Re: Cannot Apply Face to Separate Component

jhackney1972 — Tue, 22 Dec 2020 21:11:46 GMT

Please attach your model so the forum users can try and assist you. If you do not know how to attach your model, open it in Fusion360, select the File menu and then choose Export and save the .F3D file to your hard drive. Then use the Attachments section of a reply forum post to attach it.

Re: Cannot Apply Face to Separate Component

lukemaynes — Tue, 22 Dec 2020 23:09:53 GMT

Here is the file

Re: Cannot Apply Face to Separate Component

jhackney1972 — Wed, 23 Dec 2020 01:18:18 GMT

I hope I have understood your request and copied the faces you desired. It is very important to create this as a model pattern as a sketch pattern will not only drive you up the wall but bog down Fusion 360 as well. Model is attached with a different name. Follow along with the timeline and the Screencast. Make sure you set the Rectangular Pattern to "Optimized" to make it perform better.

Re: Cannot Apply Face to Separate Component

TrippyLighting — Wed, 23 Dec 2020 01:48:18 GMT

You mean like this ?

Re: Cannot Apply Face to Separate Component

lukemaynes — Fri, 01 Jan 2021 20:28:45 GMT

Thank you sir!

Re: Cannot Apply Face to Separate Component

lukemaynes — Fri, 01 Jan 2021 20:29:47 GMT

Yes! I appreciate the help so much

Re: Cannot Apply Face to Separate Component

shahriarsifat1802164 — Sat, 02 Jan 2021 07:08:52 GMT

Hi,
Go to align tool from the modified portion of the tool bar and align them>> select rectangle pattern and pattern them.
Thank you.