topic Creating A Swept Angle in Fusion Design, Validate & Document Forum

Creating A Swept Angle

fprice3 — Fri, 19 Mar 2021 18:18:43 GMT

Hi I am new to Fusion 360 and can't figure out how to create this angle shown in red. I can make an inverted angle that's radius faces the other way but not when it's the way it is. Also I can't find how to sweep this angle to go around the path of a circle. There might be an obvious answer to this but I can't seem to work it out so any help would be very much appreciated 🙂

Re: Creating A Swept Angle

PinRudolf — Fri, 19 Mar 2021 18:38:40 GMT

Hey, check out the modify commands; there is a command there that's called Fillet. The fillet command can take material away but it can also add material in existing corners. 🙂

Re: Creating A Swept Angle

g-andresen — Fri, 19 Mar 2021 19:10:02 GMT

Hi,

In which mode do you work? > Sketch, Solid ...?

Please share the file.

File > export > save as f3d on local device > attach it to the next post.

günther

Re: Creating A Swept Angle

jhackney1972 — Fri, 19 Mar 2021 20:22:43 GMT

I will make a guess here that you are trying to place a fillet between two bodies and it is being placed inside instead of outside as you desire. Take a look at the Screencast and note how the fillet in incorrect when I have two bodies but is correct when I only have one. As requested, please attach your model for absolute proof and diagnosis.