topic Re: Join an assembly to a model in Fusion Design, Validate & Document Forum

Join an assembly to a model

VGBenjamin — Sat, 27 Mar 2021 13:28:26 GMT

Hello,

In my model, I have create a drawer made from 5 components. Then I have added a rigid group join to join all those components together. But after that when I am making a join between the drawer and the model, only one of the component is moving.

Regards,

Re: Join an assembly to a model

VGBenjamin — Sat, 27 Mar 2021 13:36:14 GMT

Sorry for the duplicate issue I had a timeout. I don't know to remove this one...

Re: Join an assembly to a model

jhackney1972 — Sun, 28 Mar 2021 15:40:13 GMT

What you are describing is completely normal, you just did not go far enough in your process to realize it. When placing a joint between a component of a Rigid Group and another component in your assembly, only the component, in the Rigid Group you are applying the joint to will move initially. Once you select OK to the joint, the rest of the Rigid Group will follow. Take a look at the Screencast.

If this solves your forum question, please make sure to select Accept Solution to make it available to others.

Re: Join an assembly to a model

VGBenjamin — Sun, 28 Mar 2021 18:56:13 GMT

Hello,

Yes I understood that by watch the video and had small tear in my eyes... 😄

Thank again!