topic Re: Parametric Model, Having issues finding the correct formula. in Fusion Design, Validate & Document Forum

Parametric Model, Having issues finding the correct formula.

jason.brain — Sat, 27 Mar 2021 15:49:57 GMT

Hi Guys,

I am having a bit of mind meltdown. I have made a parametric model and am having a bit of problem spacing the drawers.

The drawer front sketch should autocalculate depending on the number of drawers and cabinet height.

the rectangular pattern at the end should calculate the amount of drawers and ideally space them with a drawer gap in between to the height of the cabinet?

Any help greatly appreciated.

jay

Re: Parametric Model, Having issues finding the correct formula.

jhackney1972 — Sun, 28 Mar 2021 00:50:23 GMT

Take a look at the Screencast for a couple of suggestions to make your work in parameters a lot easier and also some things specific to your model. Model is attached.

Re: Parametric Model, Having issues finding the correct formula.

jhackney1972 — Sun, 28 Mar 2021 17:32:15 GMT

This topic was double posted and I am hoping you will still take a look at my solution and Screencast. I feel I have a couple of good ideas to share.

Re: Parametric Model, Having issues finding the correct formula.

jason.brain — Fri, 09 Apr 2021 16:24:39 GMT

Hi John,

Apologies for the lateness of reply. I did not relkise I had double posted. This is an excelent solution and I have learned a gret deal from it. Thankyou for your time!

Jason