topic Re: How to Turn-off Pre-Selection Highlighting on Fusion 360 in Fusion Design, Validate & Document Forum

How to Turn-off Pre-Selection Highlighting on Fusion 360

karntarat — Tue, 06 Apr 2021 10:45:47 GMT

I Would like to know about How to Turn-off Pre-Selection Highlighting on Fusion 360.

when I drag a mouse pass to the body, face, edge or component, Highlighting is shown every time.

Sometimes Fusion 360 is not responsive and Hange.
.
I would like to see Highlighting when I click selected geometry only.

Re: How to Turn-off Pre-Selection Highlighting on Fusion 360

TrippyLighting — Tue, 06 Apr 2021 13:29:23 GMT

That can unfortunately not be done.

Re: How to Turn-off Pre-Selection Highlighting on Fusion 360

karntarat — Wed, 07 Apr 2021 03:26:48 GMT

Thanks for getting back to me.

Re: How to Turn-off Pre-Selection Highlighting on Fusion 360

justadudemakingstuff — Fri, 08 Apr 2022 20:42:02 GMT

Why is this unable to be done? This may turn me away from Fusion, I loved this program so much, have built various companies off of the inventions I have designed, but when Autodesk updated Fusion and added this **** "feature", my drawing efficiency dropped like a stone in a lake. I hate doing what I once loved to do, design in Fusion, simply because of this, it is like being in stop and go traffic, I can work for a second, and then all of a sudden, my cursor highlights the entire body and fusion stutters, and I have to wait and wait. Over, and over, for every **** fillet.

Please, please go back to the superior way that Fusion used to be. This ruins it. I will be forced to switch back to SolidWorks over this single issue.

Re: How to Turn-off Pre-Selection Highlighting on Fusion 360

TrippyLighting — Fri, 08 Apr 2022 21:34:04 GMT

@justadudemakingstuff wrote:

...but when Autodesk updated Fusion and added this **** "feature",

The pre-selection highlighting has not been added in the time I've used Fusion 360 and that is since late 2014.

There are various techniques I use to limit the effect where feasible.

While working on a sketch I turn off the profile view. I might Isolate components or assemblies, and also might set "stuff" too unselectable so I can still see it but not select it.