topic Re: Make closed body in Fusion Design, Validate & Document Forum

Make closed body

Anonymous — Wed, 12 May 2021 23:20:40 GMT

I have given up trying to close this body. Clicking in sketch line to line on all these points to make a closed loop so i can add a surface patch fails each time to become a loop and i cannot figure out why. There must be an easier way to put a lid on the bottom of this model and make a body from it. Please help!

Re: Make closed body

jeff_strater — Wed, 12 May 2021 23:28:14 GMT

I would just use Patch + Stitch:

Re: Make closed body

davebYYPCU — Thu, 13 May 2021 00:02:40 GMT

I have too. You can patch it in a fashion, but still will not seal up, this corner is the area of concern, without a timeline, and stl basis, not worth more time, quicker to make it in Fusion from the get go.

Might help...

Re: Make closed body

Anonymous — Thu, 13 May 2021 05:53:31 GMT

Thanks for your time, put me on the right course. Was trying to delineate all points manually into a polygon first. You indeed illustrated that there is a much easier way.