https://forums.autodesk.com/t5/fusion-design-validate-document/project-fail/m-p/10556833#M75854 <P>That is a new one for me thanks, Dave.</P> Thu, 19 Aug 2021 04:59:11 GMT daniel_lyall 2021-08-19T04:59:11Z https://forums.autodesk.com/t5/fusion-design-validate-document/project-fail/m-p/10556806#M75852 <P>When doing a project the projected geometry is turning into sketch lines, not project geometry I can repeat it. 3D project works so am using it to do what I need.</P> <P>&nbsp;</P> <P>&nbsp;</P> <P><IFRAME src="https://screencast.autodesk.com/Embed/Timeline/f171c6c3-976f-4d28-91da-5655a6aedec8" width="640" height="620" frameborder="0" allowfullscreen="allowfullscreen" webkitallowfullscreen="webkitallowfullscreen"></IFRAME></P> <P>&nbsp;</P> <P>I can PM the Model only.</P> Thu, 19 Aug 2021 04:38:45 GMT https://forums.autodesk.com/t5/fusion-design-validate-document/project-fail/m-p/10556806#M75852 daniel_lyall 2021-08-19T04:38:45Z https://forums.autodesk.com/t5/fusion-design-validate-document/project-fail/m-p/10556820#M75853 <P>Blue lines because you are not ticking the Keep Link box, (-0.27)</P> <P>hard to tell from the video.</P> <P>&nbsp;</P> <P>Might help....</P> Thu, 19 Aug 2021 04:47:59 GMT https://forums.autodesk.com/t5/fusion-design-validate-document/project-fail/m-p/10556820#M75853 davebYYPCU 2021-08-19T04:47:59Z https://forums.autodesk.com/t5/fusion-design-validate-document/project-fail/m-p/10556833#M75854 <P>That is a new one for me thanks, Dave.</P> Thu, 19 Aug 2021 04:59:11 GMT https://forums.autodesk.com/t5/fusion-design-validate-document/project-fail/m-p/10556833#M75854 daniel_lyall 2021-08-19T04:59:11Z