https://forums.autodesk.com/t5/fusion-design-validate-document/making-copy-of-sheet-metal-component/m-p/10640767#M73481 <P>You have to check the "Copy" checkbox&nbsp;<U>before</U> you move the component.&nbsp; Also, make sure that the type is set to Component, not Bodies.</P> <P>&nbsp;</P> <DIV class="iframe-container" style="position: relative; height: 0px; margin: 0px; padding-bottom: 96.875%;"><IFRAME src="https://screencast.autodesk.com/Embed/Timeline/10b08508-ba49-4c9c-ba68-7c1e7b0c785d" width="640" height="620" frameborder="0" scrolling="no" allowfullscreen="allowfullscreen" webkitallowfullscreen="webkitallowfullscreen" style="position: absolute; left: 0; top: 0; width: 100%; height: 100%;"></IFRAME></DIV> Wed, 22 Sep 2021 20:31:14 GMT jeff_strater 2021-09-22T20:31:14Z https://forums.autodesk.com/t5/fusion-design-validate-document/making-copy-of-sheet-metal-component/m-p/10640751#M73480 <P>Im working on a design right now that has the same exact component on both sides of the assembly.&nbsp; I was thinking I could just highlight the finished side then move/ copy it over 5 inches so its on the other side.&nbsp; For some reason the "copy" check box in the move/copy toolbar is always greyed out.&nbsp; Am I forgetting a step? is there an easier way to copy the whole component?&nbsp; Thanks.&nbsp; Ill attach a picture so you can see what im talking about.</P> Wed, 22 Sep 2021 20:21:15 GMT https://forums.autodesk.com/t5/fusion-design-validate-document/making-copy-of-sheet-metal-component/m-p/10640751#M73480 WeekenderSolutions 2021-09-22T20:21:15Z https://forums.autodesk.com/t5/fusion-design-validate-document/making-copy-of-sheet-metal-component/m-p/10640767#M73481 <P>You have to check the "Copy" checkbox&nbsp;<U>before</U> you move the component.&nbsp; Also, make sure that the type is set to Component, not Bodies.</P> <P>&nbsp;</P> <DIV class="iframe-container" style="position: relative; height: 0px; margin: 0px; padding-bottom: 96.875%;"><IFRAME src="https://screencast.autodesk.com/Embed/Timeline/10b08508-ba49-4c9c-ba68-7c1e7b0c785d" width="640" height="620" frameborder="0" scrolling="no" allowfullscreen="allowfullscreen" webkitallowfullscreen="webkitallowfullscreen" style="position: absolute; left: 0; top: 0; width: 100%; height: 100%;"></IFRAME></DIV> Wed, 22 Sep 2021 20:31:14 GMT https://forums.autodesk.com/t5/fusion-design-validate-document/making-copy-of-sheet-metal-component/m-p/10640767#M73481 jeff_strater 2021-09-22T20:31:14Z